11.10.2016

3D Sleigh

Pin It

 Making this die 3D is easier then you might think. Cut a 1 x 4 inch strip, then score 3/4" on each side.  You will need to use your bone folder to curve those 3/4" pieces to match the curve of the sleigh.  Then I used the fine tip glue pen to adhere it.  You will need to hold one side till it dries, then do the other.
S&P Recipe:
Cookie Cutter Christmas stamp set (142043)
Cookie Cutter Builder Punch (140396)
Santa's Sleigh Thinlits Die (140278)

1 comment: