scarecrow tootsie pop

Pin It

You have all seen the ghost toosie pop. How 'bout a scarecrow! Made with a coffee filter just like the little broom.

S&P Recipe:
Jack of all trades stamp set (w...122620, c...122622)
Houndstooth and Scaringbone DSP (126906)
2-1/2" Circle punch (120906)
1" Circle punch (119868)

Instructions-

• stamp a face just below the center of a coffee filter
• cover your tootsie pop with 2 coffee filters and wrap with twine
• tie a piece of ripped fabric around the neck
• place a 4" piece of ribbon that is shredded at the ends, on the head of the scarecrow
• use the 2-1/2" circle punch for the brim
• then punch the 1" circle in the center of the brim
• make a cone with half of a 2-1/2" circle, overlap by about 3/4 of an inch
• use glue dots to adhere cone to the head
• place glue dots on the front and back of the inside of the brim
• slide the brim down over the cone
• cut a little section on each side of the coffee filter, pull up peices and tie twine around to make arms
• glue a few little scraps of DSP on scarecrow for patches