This fun little foxy treat can be filled with anything. Inside ours is chap stick. It's pretty simple, below are some pics of each step.
start with a 5 x 6 inch piece of DSP
score at 1-3/4 and 3-1/4 inches on the 5 inch side
then at 1-1/2 and 4-1/2 inches on the 6 inch side.
Then just cut the corners out along along the score lines
This next one is a little bit tricky. Below are a few pics.
start your score right in the middle. Just mark it for now.
Now slide your stylus down.
Stick your DSP into position with your stylus in the corner lined up with the mark you made in the middle, up where my finger is. (I hope that made sense, comment below if I should do a video on it)
Finally you snip off one of the little wings you made, the other you will glue down.
Now just fold it together, glue and punch a hole in the top for a ribbon.
S&P Recipe:
Fox Builder punch (141470)
A Little Foxy DSP Stack (141637)
Foxy Friends stamp set (141549)